1040 Hard Disk Drive Assembly - Lenovo V480s Hardware Maintenance Manual

• "1010 Battery pack" on page 37
• "1020 Bottom slot cover" on page 38
Removal steps of memory modules
Release the two latches on both edges of the socket at the same time in the direction shown by the arrows
1 , and then unplug the memory module in the direction shown by the arrow
When installing: Insert the notched end of the memory module into the socket. Press the memory module
firmly, and pivot it until it snaps into place. Make sure that it is firmly installed in the slot and does not
move easily.
Note: If only one memory module is to be installed on the computer you are servicing, the memory module
must be installed in SLOT-0 (

1040 Hard disk drive assembly

For access, remove these FRUs in order:
• "1010 Battery pack" on page 37
• "1020 Bottom slot cover" on page 38
1
2
1
a lower slot), but not in SLOT-1 (
b
2 .
b upper slot).
a
.
Chapter 7 Removing and replacing a FRU
39