Listening To An Aux/Tape Input Soarce - Kenwood HD-7 Instruction Manual

Listening to an AUX/TAPE input source
28
Adjustment of the input level at the time of AUX selection
When the output level of the source equipment connected to the AUX terminal does not match the input
level of this unit (when the volume is too high or too low), it can be adjusted.
1 Select "AUX INPUT ?" as follows.
1 Press the "menu" key.
2 Select "AUX INPUT ?" with the volume/
multi control knob.
3 Press the "set" key.
POWER
1 2 3
4 5 6
7 8 9
SET
0 +10
ENTER
DISPLAY TIME CLEAR
TUNER/BAND 1,2
AUX CD
6
/TAPE
4 ¢ 7
P.CALL STOP
1 ¡
AUTO/MONO
TUNING
DOWN UP
SLEEP REPEAT RANDOM P.MODE
TIMER SOUND MUTE
VOLUME
DOWN VOLUME UP
1. Press the AUX/TAPE key.
When the AUX/TAPE key is pressed, the unit switches to exter-
nal input or tape.
2. Select external input or tape.
When the AUX/TAPE key is pressed for at least two seconds, the
input is switched as follows.
3. Start playback of the external source.
4. Adjust the volume.
2 2
1 AUX
: Playback of the equipment connected to the
AUX terminal at the rear.
2 TAPE
: Playback of the equipment connected to the
TAPE terminal at the rear.
2 Adjust the input level with the volume/
multi control knob.
The input level can be adjusted from -5 to +2.
3 Press the "set" key to confirm the input
level.
menu
set
volume/multi control
II
HD-7/EN
4 4