Setting Up The Radio - Honeywell MX8 Quick Start Manual

Setting Up the Radio

If the access point uses an authentication protocol
(WEP, LEAP, etc.), your radio must use the same
authentication. Please contact your IT department for
WEP keys or LEAP credentials. Please refer to the
MX8 Reference Guide for information on using WPA.
1. Tap Start > Programs > Summit > SCU OR
tap the Summit Client Utility icon on the
desktop.
2. Tap the Admin Login button and enter the
password (default = SUMMIT).
3. Tap the Profile tab and make sure the Default
profile is selected.
4. Select SSID and enter your SSID value.
5. If the access point is using WEP, select WEP
from the Encryption pull down list.
6. Tap the WEP keys/PSKs button and enter the
WEP Key(s) and tap OK. Skip to step 12.
7. If the access point is using LEAP, select LEAP
from the EAP Type pull down list.
8. Select WEP EAP from the Encryption pull down
list.
9. If the Cisco/CCS certified AP is configured for
open authentication, set the Auth Type radio
parameter to Open.
10. If the AP is configured for network EAP only, set
the Auth Type radio parameter to LEAP.