My Powertouch Is Not Responding; My Powertouch Is Beeping. What Does That Mean; Powertouch Does Not "Learn" New Commands Or Functions; I Want To Clear All The Items In Powertouch And Make It To The Factory-Set Default Condition - Kenwood VR-5900 Sovereign User Manual

PowerTouch

My PowerTouch is not responding

• Make sure you are within the operating range for PowerTouch. See
"How is PowerTouch Powered ?" on page 5 of this manual.
• Replace the batteries. See Chapter Two of the Connections and Setup
Guide.
• If you're using an IR receiver, make sure it is connected properly and
turned on. See Chapter Four of the Connections and Setup Guide.
• Check the contrast of the PowerTouch's screen is adjusted properly.
See "How Do I See PowerTouch's Screen More Clearly?" on page 74.

My PowerTouch is beeping. What does that mean?

The following table includes information about PowerTouch beeps:
Number Tone
1 high
1 low
2 high
2 low

PowerTouch does not "learn" new commands or functions.

• Check that the distance between PowerTouch and the device's remote
is properly set. Do not place the devices remote right against
PowerTouch.
• Check whether the PowerTouch is too close to the receiver, a TV, high-
frequency fluorescent lighting or other electrical appliance.
• "Learning" may be not carried out with some devices' remote.
I want to clear all the items in PowerTouch and make it to the fac-
tory-set default condition.
• While pressing and holding the CONFIRM and VOLUME DOWN
button, use the stylus to press the RESET button at the bottom of the
battery case.
102
Meaning
Confirms your most recent button push or
touch
Indicates that your most recent button
push or touch could not be performed
Confirms learning or copying
Indicates that learning or copying was not
successful