How Do I Adjust the Surround Modes?
Checking the Input signal during playback
During playback of Dolby Digital, MPEG or DTS signal, the surround
identification signal in the input is identified and displayed by means of
the L, C, R, SR, SB (or S), SL and LFE icons.
1. Press the F.SHIFT = 10 (STATUS)* button on Remote Control unit.
/8
1
1
/7
1
2
4
5
7
8
+10
0
+100
10
11
12
After 8 seconds, the display goes off.
L
C
LFE
SL
SB
SR
or
S
Example:
5.1 ch encoded Dolby Digital
* When an operation is described as [F.SHIFT = 10 (STATUS) button],
for example, press the F.SHIFT button and press the next button (the 10
(STATUS) button in this case) within 8 seconds.
Input Status
3
6
9
L : left channel
R
C : center channel
R : right channel
SL : left surround channel
SR : right surround channel
SB : left and right surround back channel
S : surround channel
LFE : low frequency effect channel
: identified signal
Dolby
Digital
F.Auto
2 ch Dolby Digital
21