Digital Connections - Kenwood KR-V888D Instruction Manual

Digital connections

Make connections as shown below.
The digital in jacks can accept either Dolby Digital (AC-3) or PCM signals (the input signal type is detected automatically).
When connecting the related system components, be sure to also refer to the instruction manuals supplied with the
components you are connecting.
Do not connect the power cord to a wall outlet until all connections are completed.
Connect components capable of output-
ting Dolby Digital (AC-3) or standard PCM
format digital signals.
AC-3 VIDEO2
DIGITAL PLAY IN
IN (OPTICAL)
AC-3 RF Demodulator DEM-999D
1
1 POWER indicator
Lights (red) when the power switch (5) is set to ON .
2 LOCK indicator
Lights when an AC-3 RF signal is input to the AC-3 RF INPUT jack (4).
3 AC-3 DIGITAL OUTPUT (coaxial)
Connect this jack to the coaxial AC-3 DIGITAL IN jack on your receiver.
It outputs AC-3 coaxial digital signals when the POWER (5) is set to
ON and an AC-3 RF signal is input to the AC-3 RF INPUT jack (4).
or
RCA
pin
cord
VIDEO3
PLAY IN
(COAXIAL)
2
LASER DISC RF DEMODULATOR DEM-999D
POWER LOCK
OPTICAL DIGITAL OUT
(AUDIO)
Optical fiber cable
COAXIAL DIGITAL OUT
(AUDIO)
RCA pin cord
AC-3 DIGITAL AC-3 RF DC IN
OUTPUT INPUT 12V
OFF ON
@ #
AC-3 RF OUT
RCA pin cord
LASER DISC RF DEMODULATOR DEM-999D
POWER LOCK
To connect an LD player with a DIGITAL RF OUT.
Connect the LD player to the KENWOOD RF digital
demodulator (DEM-999D). Then connect the demodu-
lator to the VIDEO 3 DIGITAL IN.
Connect the video signal and analog audio signals to the
VIDEO 3 jacks. (See "Connecting video components".)
3
AC-3 DIGITAL
OUTPUT
EXTERNAL DC SUPPLY DC 12V
4 AC-3 RF INPUT
Connect this jack to the AC-3 RF OUTPUT jack on your LD player.
5 POWER switch
Use to switch the power ON/OFF.
6 DC IN (12V) jack
Connect this jack and inlet power cord to the AC adaptor supplied with
your demodulator. Connect the power cord to a wall outlet after
completing all of the other connections.
Place the power supply away from the demodulator,
receiver, and any antennas.
Setting up the system
KR-V888D (En/T)
Component with an AC-3 (or
PCM) OPTICAL DIGITAL OUT
Connect the video signal and analog
audio signals to the VIDEO 2 jacks.
(See "Connecting video components".)
Component with an AC-3 (or
PCM) COAXIAL DIGITAL OUT
Connect the video signal and analog
audio signals to the VIDEO 3 jacks.
(See "Connecting video components".)
(AUDIO)
4 5 6
AC-3 RF DC IN
INPUT 12V
OFF ON
@ #
1 1