The External Monitor Remains Blank; The External Monitor Is Blank Or The Image Is Unstable - Fujitsu Siemens Computers Amilo Si 2654 Operating Instructions Manual

The external monitor remains blank

Monitor
Cause
Monitor is switched off.
Power saving has been activated (monitor is
blank).
Brightness is set to dark.
Screen output is set to the notebook's LCD
screen
The external monitor's power cable or data
cable is not connected properly.

The external monitor is blank or the image is unstable

Screen Monitor
Cause
The wrong external monitor has been selected
or the wrong screen resolution has been set for
the application program.
AMILO Notebook Si 2654 Operating instructions, edition 1
Troubleshooting
► Switch the external monitor on.
► Press any key to continue.
► Adjust the brightness of the monitor.
► Press the key combination
(switch screen output).
► Switch off the external monitor and the
notebook.
► Check whether the power cable is plugged
properly into the external monitor and into
the power socket.
► Check whether the data cable is properly
connected to the notebook and the external
monitor (if it is plugged in with a connector).
► Switch on the external monitor and the
notebook.
Troubleshooting
► Terminate the application program in
Windows by pressing
fault persists after closing the program,
switch over to the notebook's internal LCD
screen with
Fn
following setting:
► Set the screen resolution: Select the
required resolution with Startsymbol –
(Settings) – Control Panel – Appearance and
Personalization – Personalization: Adjust the
screen resolution as required.
► Select monitor: Right-click on the desktop.
Under Personalization – Display Settings
choose monitor 1 or 2 and under Advanced
Settings – Monitor choose the correct monitor.
Troubleshooting and tips
Fn + F10
Alt + F4 . If the
+ . Change the
F10
59