Salus KL08RF Installation And Wiring Manual

iT600 Wiring Centre KL08RF 028 V9.qxp_Layout 1 04.12.2014 12:30 Strona 1
L N
Optional wireless
receiver RX10RF
www.salus-controls.com Technical Helpline +44 (0) 1226 323 961
GROUP 1
BATTERY POWERED GROUP CONTROL GROUP 1 GROUP 1
PROGRAMMABLE THERMOSTAT THERMOSTAT THERMOSTAT
ROOM THERMOSTAT MAINS POWERED (VS20WRF) (VS10WRF)
(MODEL VS20WRF) (MODEL VS20WRF) (MODEL VS10W (MODEL VS10WRF) WRF) WRF)
SUPPLIED CABLES
UNDERFLOOR HEATING MANIFOLD
GROUP 2
GROUP 1 GROUP 2 GROUP 2 CONTROL
THERMOSTAT THERMOSTAT THERMOSTAT PROGRAMMABLE
(VS20WRF) (VS10WRF) (VS20WRF) ROOM THERMOSTAT
N L
External power supply
230V TO UFH PUMP
Optional boiler connection
2
1.5MM CABLE (INSTALLER SUPPLIED)
Installation and Wiring Guide
STANDALONE
Meets the following EC Directives
• Electro-Magntic Compatibility directive 2004 / 108 / EC
• Low-voltage Directive 2006/95/EC
These instructions apply to the SALUS model stated above.
Warning
This product must be fitted by a competent person, and
installation must comply with the guidance, standards and
regulations applicable to the country or state where the
product is installed. Failure to comply with the requirements
of the relevant guidance, standards and regulations could lead
to injury, death or prosecution.
Warning
Always isolate the AC mains supply before installing or working
on any components that require 230 V AC 50Hz supply.
Warning
The earth terminals on the KL08RF are for earth parking only.
These terminals provide no earth protection.
For PDF Installation guide go to www.salus-controls.com
Maintaining a policy of continued product development SALUS Controls plc reserves the right to change
specification, design and materials of products listed on this installation guide without prior notice.
Issue Date: October 2014 Document Number 00106
KL08RF