Lexmark MS410 Series Service Manual page 150

4
Cut the cable (B) not less than 1 inch from the solenoid.
Installation notes:
a
Cut the replacement solenoid cable not less than 1 inch from the solenoid.
b
Strip a 1/8‑in. length of insulation from the ends of all cables.
c
Insert a wire from the printer into one end of the insulated displacement connector (IDC).
Note: Make sure the stripped end of the wire is positioned under the contact element.
d
Insert a wire of the same color from the solenoid into the other end of the IDC.
Note: Make sure the stripped end of the wire is positioned under the contact element.
e
Squeeze the IDC to partially lock the wires in place, and then use a pair of pliers to crimp the IDC.
f
Repeat steps c–e for the other wire.
g
Reinstall the MPF solenoid.
B
Repair information
150
4514-420, -430
A