Connecting An Analog Camera; Connecting An Nsre-S200 - Sony Ipela NSR Series Installation Manual

Connecting an Analog Camera

Connect the analog camera using the supplied analog
camera input cable.
To control pan, tilt, and zoom operations, connect a
camera control cable to the RS-232C connector or the
RS-422/485 connector (four rightmost pins on the alarm
output connector). (Only one of these connectors (RS-
232C, RS-422, RS-485) can be used at any one time.)
Analog camera cable input connector
Analog camera input cable
Analog camera
Connection Example
Analog cameras PTZ
(RS-422 control)
Analog cameras PTZ
(RS-232 control)
18
Step 2: Connections
Video input
connector (black)
Audio input
connector
Audio device
(white)
Analog cameras PTZ
(RS-485 control)
Caution
When using cameras and power supply units that
superimpose DC voltage on the video coaxial cable, pay
close attention to the coaxial cable wiring. If the camera
cable on which DC voltage is superimposed is
connected to the NSR, malfunctions may occur.
Analog cameras
Power supply unit
Coaxial cable on
which DC voltage
is superimposed
Notes
• The NSR-1050H is standard equipped with the analog
camera cable input connector, but the NSR-1200/1100
requires an NSBK-A16/A16H (optional) expansion.
• When using pan, tilt, and zoom operations, you must
configure a unique control number. For details on
configuring control numbers, refer to the operating
instructions for the analog camera.
• For details on the pin assignment for the RS-422/485
connector, see "Pin Assignment of I/O Port"
(page 32).

Connecting an NSRE-S200

Use the mini-SAS cable supplied with the optional
NSRE-S200 to connect the NSR-1200/1100/1050H to
the NSRE-S200 as follows.
You can connect up to seven NSRE-S200 units to the
NSR-1200/1100/1050H.
For details on connection configurations, see "NSRE-
S200 Connection Example" (page 30).
Note
Be sure to connect the NSR-1200/1100/1050H and the
NSRE-S200 before turning on the power.
VIDEO
NSR
OUT
POWER NETWORK 1 2 3 HDD 1 2 3 4 STATUS 1 2 3 4 ERROR REC
Coaxial cable
Be careful not to connect the
coaxial cable for the analog
cameras to the NSR unit.