Rip Settings; Ipv6 Route Settings; Ipv6 Default Gateway - TP-Link Archer D5 User Manual

Archer D5 AC1200 Wireless Dual Band Gigabit ADSL2+ Modem Router User Guide
static route.
Subnet Mask: It determines which portion of an IP Address is the network portion, and

which portion is the host portion.
Gateway: Type in the correct gateway address for the static route.

Interface: Select the Interface from the drop-down list.

 Status: Select Enabled or Disabled from the drop-down list.
3. Click Save to save your settings as shown in Figure 4-66.
To modify or delete an existing entry:
Find the desired entry in the table.
1
Click Edit as desired on the Edit column.
2
Click the Enable/ Disabled Selected button to make selected entries enabled/ disabled.
Click the Delete Selected button to delete the selected entries.

4.12.3 RIP Settings

Choose "Route Settings""RIP Settings", you can see the RIP (Routing Information Protocol)
screen which allows you to configure the RIP.

Note:
RIP cannot be configured on the WAN Interface which has NAT enabled (such as PPPoE).

4.13 IPv6 Route Settings

Choose "IPv6 Route Settings", it includes two menus: IPv6 Default Gateway and IPv6 Static
Route. The detailed descriptions are provided below.

4.13.1 IPv6 Default Gateway

Choose "IPv6 Route Settings""IPv6 Default Gateway", you can see the Default Gateway
screen. You can select a WAN Interface from the drop-down list as the system default gateway.
Figure 4-67
77