Related Manuals for Vivotek AE-235
Summary of Contents for Vivotek AE-235
- Page 1 AE-235 Infrared Illuminator Enclosure Installation Guide Rev. 1.0 IP Sur veillance...
-
Page 2: Specifications
2. Electrical Connections: Only a qualified electrician allow to make electrical connections. Specifications Model Name AE-235 LED Quantity 12 IR LEDs IR Light Distance Approach To 80 ~ 100M IR Light ON/OFF... -
Page 3: Physical Description
Physical description Lens cap with heater IR LEDs behind temper glass IR board and IR board bracket Thermostat switch Day/Night trigger: controls the color/mono Universal IR control circuit board: to mode switch for D/N cameras control color/mono switching and IR on/off synchronization Camera bracket Heater... -
Page 4: Interface Connections
AC input wiring: connect power lines to an external power cord. Power cords Connector Block Brown: Line Yellow/Green: Earth Blue: Neutral Interface Connections Once a camera is installed, you can connect the 12V DC phone jack connector to power the camera. -
Page 5: Hardware Installation
Configure the camera's IR cut filter setting (if your camera comes with it) to "Synchronize with digital input." The configuration option can be found in Configuration > Media > Image > General settings > Day/Night settings > IR cut filter. Hardware Installation 1. - Page 6 4. Assemble the mounting bracket arm (A).(B).(C). 110.00mm 83.00mm 8.00mm Dimensions of Bracket Base 5. Feed the Ethernet cable and power cord from hole (D) on the bottom of the enclosure through the mounting bracket arm. 6. Pan and tilt the enclosure to aim at the monitored area. Ethernet cable Power cord 7.