VIVOTEK Mounting Accessories
AM-71C Conduit Box
Installation Guide
Revison History:
Rev. 1.0: Initial release
I
Compatible VIVOTEK Cameras
Compatible cameras/brackets
A: IT9360-H, IT9380-H
B: IB9389 series, IB9360-H, IB9380-H, IB9368-HT, IB9388-HT
C: FD9360-H, FD9380-H
Mounting Dimensions
3
Attach the included alignment sticker to a preferred position.
Drill holes on the wall and install the junction box. If space
behind the wall allows, you may also pass cables through the
wall.
Pass the camera's Ethernet cable through the center hole of
5
the box and the rubber seal.
Part no.: 625055100G
Accessory Ordering part no.: 100220500G
Package Contents
x4
x4
4
Loosen and remove the camera top cover. (Using one of
the supported cameras as an example)
Install the waterproof components of the cable gland to your
6
Ethernet cable following the QIG of your camera. The cable
gland will be placed within the protection of the box.
Installation
II
Remove the top cover and unhook the tether wire.
1
If using the bottom hole,
seal the center hole.
x4
Make sure the rubber seal is properly installed to the center
7
hole. The outer rim of the seal must be through and cover the
edge of the hole.
5.5 ~ 6mm
9
Secure the top cover by fastening 4 hex socket screws.
A 3/4" conduit is required for routing the cables with waterproof
connection.
2
Install the cable gland and pass cables through it.
OR
3/4"
8
A: IT9360-H, IT9380-H
B: IB9389 series, IB9360-H, IB9380-H, IB9368-HT, IB9388-HT
C: FD9360-H, FD9380-H
Install the camera using the corresponding mounting holes with
10
the included hex socket screws.