JVC KD-LH915 Service Manual page 15

QQ
3.2.4 Removing the clamper unit 3 7 63 1515 0
(See Figs.5 and 6)
• Remove the mechanism control board, top cover and mecha-
nism section.
(1) From the bottom side of the mechanism section, remove
the clamper 2 spring. (See Fig.5)
(2) Release section e of the clamper spring from the bending
section of the chassis base. (See Fig.6)
(3) Move the clamper unit in the direction of the arrow and re-
lease the joints (f, g). (See Fig.5)
(4) Take out the clamper unit in an upward direction. (See
Fig.5)
3.2.5 Reattaching the clamper unit
(See Figs.5 to 9)
(1) From the bottom side of the mechanism section, attach the
clamper spring to the clamper unit. (See Figs.5 and 9)
(2) Move the clamper unit to set the joints (f, g) to each projec-
tion of the chassis base. (See Fig.5)
(3) Make sure that section h of the clamper unit is inserted to
the notch of the chassis base. (See Figs.5 and 8)
(4) Move the clamper spring to the outside of the bending part
of the chassis base. (See Fig.6)
Caution:
When reattaching the clamper unit, temporarily hook the
end of the clamper spring as shown in the figure to make
the work easy. (See Fig.9.)
(5) Attach the clamper 2 spring to the chassis base and
clamper unit. (See Figs.5 and 7.)
TE
L 13942296513
www
.
http://www.xiaoyu163.com
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
Clamper spring
f
Chassis base
Clamper 2 spring
Q Q
3 6 7 1 3 1 5
Clamper spring
Chassis base
co
.
9 4 2 8
Clamper unit
h
g
Fig.5
0 5 8 2 9 9 4 2 8
e
Fig.6
m
(No.MA156)1-15
9 9
9 9