JVC KW-XC55 Service Manual page 17

QQ
3 7 63 1515 0
3.3.10 Disassembling the flywheel assembly (F)
(See Fig.19 and 20)
(1) Push and turn counterclockwise the spring holder (F) to re-
lease the three joints p on the bottom of the flywheel.
(2) The spring holder (F), the TU spring and the friction gear
play come off.
(3) Remove the polywasher and felt.
3.3.11 Disassembling the flywheel assembly (R)
(See Fig.19 and 20)
(1) Push and turn clockwise the spring holder (R) to release
the three joints q on the bottom of the flywheel.
(2) The spring holder (R), the FF spring and the friction gear
FF come off.
(3) Remove the polywasher and the felt.
3.3.12 Removing the reel board
(See Fig.21 and 22)
(1) Remove the two screws C attaching the reel board.
(2) Move the reel board in the direction of the arrow to release
the joint r.
(3) Unsolder the wires if necessary.
CAUTION:
When reattaching, confirm operation of the MODE
switch and the ST-BY switch.The mode position be-
tween EJECT and ST-BY is optimum for reattach-
ing.Connect the card wire extending from the reel board
to the FFC pad before reattaching the reel board.
Flywheel
assembly (F)
TE
L 13942296513
Joint p
Polywasher
Spring holder (F)
TU spring
Friction gear play
www
.
Flywheel assembly (F)
http://www.xiaoyu163.com
Flywheel
assembly (R)
Joints p
Joints q
Fig.19
Polywasher
Spring holder (R)
FF spring
Friction gear FF
Felt
Felt
x ao
y
i
Flywheel assembly (R)
Fig.20
http://www.xiaoyu163.com
8
C
Q Q
3 6 7 1 3
Joint q
u163
.
2 9 9 4 2 8
FFC pad
Reel board
C
Fig.21
FFC pad
CT-1 switch
Soldering
1 5 0 5 8 2 9 9 4
ST-BY switch
Fig.22
m
co
9 9
Joint r
MODE switch
2 8 9 9
(No.49784)1-17