JVC KD-DV6105 Service Manual page 4

QQ
1.2 Preventing static electricity 3 7 63 1515 0
Electrostatic discharge (ESD), which occurs when static electricity stored in the body, fabric, etc. is discharged, can destroy the laser
diode in the traverse unit (optical pickup). Take care to prevent this when performing repairs.
1.2.1 Grounding to prevent damage by static electricity
Static electricity in the work area can destroy the optical pickup (laser diode) in devices such as CD players.
Be careful to use proper grounding in the area where repairs are being performed.
(1) Ground the workbench
Ground the workbench by laying conductive material (such as a conductive sheet) or an iron plate over it before placing the
traverse unit (optical pickup) on it.
(2) Ground yourself
Use an anti-static wrist strap to release any static electricity built up in your body.
(caption)
Anti-static wrist strap
(3) Handling the optical pickup
• In order to maintain quality during transport and before installation, both sides of the laser diode on the replacement optical
pickup are shorted. After replacement, return the shorted parts to their original condition.
(Refer to the text.)
• Do not use a tester to check the condition of the laser diode in the optical pickup. The tester's internal power source can easily
destroy the laser diode.
1.3 Handling the traverse unit (optical pickup)
(1) Before disconnecting the flexible wire from the connector
on the flexible wire.
TE
L 13942296513
Caution:
If you do not follow this instruction, the DVD pickup may be damaged.
(2) Disconnect the flexible wire from the connector
(3) Remove the solders from the short-circuit points on the flexible wire after replacing the DVD pickup.
(4) Connect the flexible wire to the connector
www
.
1-4 (No.MA158)
http://www.xiaoyu163.com
1M
CN101 on the mechanism control board.
CN101 on the mechanism control board.
Flexible wire
CN101
Short-circuit points
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
Conductive material
(conductive sheet) or iron plate
CN101 on the mechanism control board, solder the short-circuit points
Q Q
3 6 7 1 3 1 5
Mechanism control board
co
.
9 4 2 8
0 5 8 2 9 9 4 2 8
m
9 9
9 9