JVC KD-DV6105 Service Manual page 19

QQ
3.2.9 Removing the DVD pickup assembly 3 7 63 1515 0
(See Fig.17 to 19)
• Remove the mechanism control board.
(1) From the bottom of the body, turn the feed gear in the di-
rection of the arrow to move the DVD pickup outwards.
(See Fig.17.)
(2) Remove the screw J attaching the thrust spring. (See
Fig.17.)
(3) Remove the DVD pickup assembly upward on the L.S.gear
side and release from sub shaft at joint r. Move the lead
screw of the DVD pickup assembly in the direction of the
arrow to release from joint s. (See Fig.18.)
Caution:
• When releasing the lead screw at joint s, the L.S.collar
comes off at the end of the lead screw. When reas-
sembling, reattach the L.S.collar to the lead screw and
engage joint s. (See Fig.18.)
• When reattaching the L.S.collar, reattach it to the point
s of the lead screw, and to the rod (M). Make sure that
the L.S.collar is set on the rod (M) spring. (See Fig.18.)
(4) Remove the screw K attaching the rack spring/ rack plate
on the DVD pickup. (See Fig.19.)
(5) Pull out the lead screw. (See Fig.19.)
Caution:
Perform adjustment after replacing the pickup.
TE
L 13942296513
www
.
http://www.xiaoyu163.com
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
DVD Pickup assembly
DVD Pickup assembly
Q Q
3 6 7 1 3 1 5
Sub shaft
r
Rack spring
Rack plate
L.S.collar
co
.
DVD Pickup
9 4 2 8
Feed gear
Thrust spring
Fig.17
s
L.S.collar
Rod(M)
Lead screw
0 5 8 2 9 9 4 2 8
L.S.gear
Fig.18
K
Lead screw
m
Fig.19
(No.MA158)1-19
9 9
J
9 9