Connecting The Power Cord - Pioneer PureVision ElitePRO-920HD Operating Instructions Manual

Preparation

Connecting the power cord

Connect the power cord after all component connections have been completed.
Plasma Display (rear view)
Media Receiver (rear view)
DIGITAL OUT
OPTICAL
I N OUT
VCR CONTROL ANTENNA/ Cable Cable
CONTROL CABLE A IN CARD CARD
IN
ANTENNA B
S400
(TS)
INPUT 2
S-VIDEO INPUT 2 INPUT 1 COMPONENT VIDEO
VIDEO R-AUDIO-L VIDEO R-AUDIO-L Y C B /P B C R /P R
SERVICE ONLY
OUT INPUT 1
MONITOR OUT S-VIDEO VIDEO R-AUDIO-L S-VIDEO R-AUDIO-L INPUT 3 INPUT 3 Y C B /P B C R /P R
INPUT 3
• Use only the supplied power cord.
• Be sure to use the specified power supply voltage;
neglecting this can result in fire or electric shock.
• For the Plasma Display System, a three-core power cord
with a ground terminal is used for efficiency protection.
Always connect the power cord to a three-pronged
outlet and make sure that the cord is properly grounded.
AC INLET AC IN
AC IN
BLACK
INPUT 3 WHITE
SYSTEM CABLE
HDMI
Noise filter
Partially eliminates noise
caused by the power source.
Power cord
Noise filter
Partially eliminates noise
caused by the power source.
Power cord
• Always turn off the power of the Plasma Display and Media Receiver
when connecting the power cords.
• Disconnect the power cord from the power outlet when the Plasma
Display System is not going to be used for a long period of time.
06
23
En