Table of Contents
Advertisement
Designer Series Gas Fireplaces
Before you begin — This unit is supplied with eight
ceramic fiber logs. Do not handle these logs with your bare
hands. always wear gloves to prevent skin irritation
from ceramic fibers. After handling the logs, wash your
hands gently with soap and water to remove any traces
of fibers.
INSTaLL LoGS aNd RoCK wooL (EMBER
MaTERIaL) IN FIREBox
1. Remove glass frame. Refer to Glass Frame Removal,
Page 31.
2. Carefully remove logs from wrapping.
3. Place left log (#1) on left end of grate. Line up two (2)
pin holes in bottom of log with two (2) pins on grate. Log
#1 will always be to the left of the control panel. Figure
42
4. Place right log (#2) on right end of grate. Line up three
(3) pin holes in bottom of log with three (3) pins on grate.
Figure 43
Left Log
(#1)
Pins
Figure 42 -
Install Left Log (#1)
LG638
DV6000 left log
28
The positioning of the logs is critical to
the safe and clean operation of this heater.
Excessive sooting and other problems may
result if the logs are not properly and firmly
positioned in the appliance. Never add
additional logs or embellishments such as
pine cones or vermiculite to the heater. only
use the logs supplied with the unit.
Failure to position the parts in accordance
with diagrams below or to use only parts
specifically approved for this heater may result
in property damage or personal injury.
Grate
LG638
Control Panel
Figure 43 -
Install Right Log (#2)
LoG PLaCEMENT
Right Log
(#2)
Control Panel
LG639
42D0200
DV6000 right log
Pins
Hide quick links:
Advertisement
Table of Contents
