Sony TRINITRON KV-27FS320 Service Manual page 158

Remote Control
Problem
I cannot operate the
remote control
I cannot change
channels with the
remote control
I lost the remote
control
Programming The Remote Control
Problem
More than one code
is listed
I entered the wrong
code number
I cannot operate a
component with the
remote control
When I changed the
batteries, the code
numbers changed
back to the factory
settings
42
Possible Remedies
Press TV (FUNCTION) when operating your TV.
Check the orientation of the batteries.
Batteries could be weak. Replace them (page 2).
Move the TV three to four feet away from fluorescent lights.
Make sure you have not inadvertently switched your TV from
the channel 3 or 4 setting if you are using another device to
change channels.
If you are using another device to control channels, be sure that
you have pressed the FUNCTION button for that device. For
example, if you are using your VCR to control channels, be sure
to press the VCR/DVD FUNCTION button (page 4).
You can use the front panel controls to access your menus,
change channels, adjust the volume, or change video inputs
(page 2). Contact your nearest Sony Dealer to order a
replacement. To find out the nearest dealer, please call our Sony
Direct Accessory and Part Center at 1-800-488-7669 (U.S.
residents only).
Possible Remedies
Try entering them one by one until you come to the correct code
for your component.
If you enter a new code number, the code number you
previously entered at that setting is erased. To reenter the
correct code number you must reprogram the remote control
(page 5).
Use the component's own remote control.
Reprogram the remote control (page 5).