Table of Contents
Advertisement
Connecting YourTV
3 7
Connecting remote IR devices
To control
the device(s):
Point the TV remote
control toward the front of the TV and press the
button for the desired function.
The signal passes
from the remote
control through
the TV to the device via the IR Blaster cable. For more
information,
see "Setting
the IR Blaster"
on page 61.
If
(Sample
Illustration)
Controlling
the device(s)
- remote control
NOTE
TheIRpass-through feature doesnotsupportall IRcontrolled devices.
Satisfactory q ualitymaynotbe attainable with certaindevices.
If you cannot locate the device's infrared sensor:
1
Turn off the device.
2
Starting at the device's lower-left corner, place the end of the
device's remote control (with the infrared emitter) so it touches the
front of the device. Press the POWER button.
(Do not use the TV's remote control for this step.)
3
If the device turns on, the sensor is located where the remote control
touched the device.
4
If the device does not turn on, move the remote control slightly to
the right and press the POWER
button again.
5
Repeat the previous steps if necessary.
Advertisement
Table of Contents
