Converting Appliance F Orusewithlpgas - Jenn-Air CCGX2420 Installation Manual

In p_anning anyinstallation, notethatthe freelengthof thisappliance's Step 5: Locate t heLPorifice s pud packet taped totheunderside o fffi
power c ord, e xtending b eyond a point 3 -3,/4" ( 9.53cm)leftofthenominal burnerbox.Thespudshavesmall n umbers s tamped onth
center o ftherearwail o ftheburner b ox, w hen viewed f rom thefrontofthe side.Thisnumber c odes theorifice diameter a nditscorre,
unit, i sapproximately 46" (117 cm). burner location. Thefollowing illustrations showcorrect L
orificespud locationfor 4 burnerand 6 burner model:
WARNING respectively.
ELECTRICAL GROUNDING I NSTRUCTI_
- THIS APPLIANCE IS EQUIPPEDWITH A THREE PRONG
INSTALLATION OF LP ORIFICE SPUDS
GROUNDING PLUGFORYOURPROTECTION A GAINST SHOCK 4 BURNER MODEL
HAZARDAND SHOULDBE PLUGGEDDIRECTLYINTO A
PROPERLY GROUNDED R ECEPTACLE, DONOT CUTORREMOVE
THEGROUNDING P RONG FROM THISPLUG.
I WARNING
THIS APPLIANCEMUST BE DISCONNECTED FROM ITS
ELECTRICAL S UPPLYAT THE WALLRECEPTACLE B EFORE
SERVICING THEAPPUANCE.
CONVERTING APPLIANCE F ORUSEWITHLPGAS (_
WARNING
Propane conversion i s tobe performed b y a JENN-AIR AUTHORIZED
SERVICER(or other qua}ifieqagency) in accordancewith the
manufacturer's instructions andallcodes andrequirements oftheauthority
having jurisdiction. Failure to followinstructions couldresultin serious
injuryor property damage. T hequalified agencyperforming t his work
assumes r esponsibility forthisconversion.
WARNING
Electrical power andgasmust b eturned offprior t oconversion. FIGURE 6
This appliance wasadjusted a t thefactory forusewithnatural g as.To 6 BURNER MODEL
convert itforusewithLPgas(propane o rbutane), eachofthefollowing
modifications must b eperformed: S IT__ _'_
A. Replace a llorifice spuds
Step1; Remove thegrates andbernerheads.
Step 2: Remove a luminum v enturi tube.
Step3: Trim a small p iece ofmasking tapetothe sizeofa dimeand _ _
affixit over t he endofa5/16"nutdriver. ,_ _,._
Step 4; Firmly press thenutdriver o ver t heorifice spud(figure 5)and __
k_senspudby turning counterclockwise. Carefully llft nut
driver o utof burner t hroat. O rifice spud should becaptured in "_
therecess. Repeat thisstep foreachburner. _ _
REMOVAL O FORIFICE SPUD __
FIGURE 7
Step6: Withthemasking tapestill in place intherecessof th_
driver, p ress an LPorifice spudintothe recess so that
snugly c aptured.
Step7: Carefully install t heorifice spudintheappropriate burner t '
byturning clockwise t otighten. T ighten to atorqueof15
inch-lbs.
Step8: Replace cylindrical aluminum venturi t ubes.Replace b
heads andgrates. I ndex eachgratetoits burner p an.
FIGURE 5 Step 9: Save theorifices r emoved from theappliance f orfuture L
4