Step 3. Insert the Film Holder
Insert the film holder into the scanner through the Front Film Holder Slot until it is
automatically pulled in by the scanner. The scanner will not pull in the film holder if the
USB cable is disconnected.
Please allow about 35 cm in front of the scanner to insert and remove the film holder.
The film holder should be able to be inserted into the scanner
On the top side of the film holder you can see '35 mm Mounted
Attention
Step 4. Scan with the SilverFast application
Launch the SilverFast launcher using the SilverFast shortcut on your Desktop. Adjust
the scan settings. Please refer to the SilverFast manual for more information about
available scan settings.
smoothly. Do not push the film holder hard.
Film Holder' or '35 mm Strip Film Holder' or '120/220 Strip
Film Holder'. Always keep this side up for correct scan results.
20