Start-Stop - Skoda 2014 Fabia Owner's Manual

›
The speed will increase continuously, if the rocker button is pressed and held
in the RES position. Release the rocker button once the desired speed is
reached. The set speed is then stored in the memory.
Decreasing the speed
›
The stored speed can be reduced by pressing rocker button
page 117 to the SET position.
›
The speed will decrease continuously, if the rocker button is pressed and
held in the SET position. Release the rocker button once the desired speed is
reached. The set speed is then stored in the memory.
›
If the rocker button is released at a speed below around 25 km/h, the speed
is not stored and the memory is erased. The speed must then be stored
again by pressing rocker button
speed of the vehicle to more than around 25 km/h.
The speed can also be reduced by depressing the brake pedal, which tempora-
rily deactivates the system.
Switching off temporarily

Read and observe and
The cruise control system can be temporarily switched off by pushing switch
» Fig. 114 on page 117 to the spring-loaded CANCEL position or by depress-
A
ing the brake or clutch pedal.
The set speed remains stored in the memory.
Briefly push rocker button to the RES position to resume the set speed af-
B
ter the clutch or brake pedal is released.
Switching off completely

Read and observe and
›
Press switch » Fig. 114 on page 117 to the right to the OFF position.
A

START-STOP


Introduction
This chapter contains information on the following subjects:
Operating conditions for the system
Operation
118
Driving
» Fig. 114
B
to the SET position after increasing the
B
on page 117 first.
on page 117 first.
System conditioned automatic start-up
Manually deactivating/activating
Information messages
The START-STOP system (hereinafter referred to just as the system) reduces
on
fuel consumption and polluting emissions and CO
engine off, e.g. when stopping at traffic lights, and starting the engine again
when moving off.
WARNING
Never let the vehicle roll with the engine switched off.
■
The brake servo unit and power steering only operate if the engine is run-
■
ning.
Operating conditions for the system

Read and observe
For the system-dependent automatic engine shutdown to operate, the follow-
ing conditions must be met.
The driver's door is closed.

The driver has fastened the seat belt.

The bonnet is closed.

The driving speed exceeded 4 km/h after the last stop.

No trailer is coupled.

Some additional conditions for the system to function cannot be either influ-
enced or recognised by the driver. Therefore, the system can react differently
in situations which are identical from the driver's view.
118
119
emissions by turning the
2
Fig. 115
Maxi DOT display: Engine is auto-
matically switched off / automat-
ic engine cut off is not possible
on page 118 first.
119
119
119
