AT&T 1739 User Manual page 6

Operation
Auto reset of answering system clock
The system will always be set automatically with incoming caller ID information.
The time will be set automatically only if you subscribe to caller ID service
provided by your telephone service provider.
Set the clock
You must set the clock so that the system announces the correct day and time
of any incoming messages. Make sure the year is correct because the day of the
week is calculated from the year. The system announces the current setting and
"To set the clock press and hold CLOCK," when you press CLOCK. To exit at
anytime while setting the clock, press
Press and hold CLOCK until the message window displays C. The system
1.
announces the default day, "To change press SKIP or REPEAT" and "To change
the hour press CLOCK."
2. To change the day setting, press
correct day is announced.
Press CLOCK. The current hour setting is announced. The correct day setting
3.
is saved.
4. To change the hour setting, press
correct hour is announced.
Press CLOCK. The current minute setting is announced. The correct hour
5.
setting is saved.
6. To change the minute setting, press
the correct minute is announced.
Press CLOCK. The current year setting is announced. The correct minute
7.
setting is saved.
�. To change the year setting, press
correct year is announced.
�. Press CLOCK. The new day, time and year are announced. The correct year
setting is saved.
To check the date and time, press CLOCK.
NOTE: In the event of a power failure, see the instructions on the bottom of the unit to reset the
clock. If the clock is not set the system will announce, "Time and day not set," before playing
each message.
Record your announcement
An announcement is the greeting callers hear when calls are answered by the
answering system.
The telephone is preset with a greeting that answers calls with "Hello, please leave
a message after the tone." You can use this default announcement, or replace it
with your own (up to 3 minutes long).
1. Press and hold
microphone at the lower right corner of the answering system, from about
� inches away. While recording,
ON/
blinks.
OFF
2. To stop recording, release
the outgoing announcement.
To review your announcement, press
To erase your own recorded announcement, press DELETE while the
announcement is playing. Calls are then answered with the default announcement.
Record memos
A memo can be up to 3 minutes and is stored as an incoming message.
1. Press and hold
microphone at the lower right corner of the answering system.
2. To stop recording, release
3. To play a memo, press
/SKIP. When the system beeps, speak towards the
ANNC
-
/SKIP. The system automatically plays back
ANNC
MEMO/ MEMO/ . When the system beeps, speak toward the
REPEAT
MEMO/ MEMO/
PLAY/ PLAY/
STOP
/STOP.
PLAY
/REPEAT or
MEMO
/REPEAT or
MEMO
/REPEAT or
MEMO
/REPEAT or
MEMO
flashes in the message window and
/SKIP.
ANNC
.
REPEAT
.
5
/SKIP until the
ANNC
/SKIP until the
ANNC
/SKIP until
ANNC
/SKIP until the
ANNC