Table of Contents
Advertisement
S - 6 3 6
L. BACKREST
(FIG. 12)
A backrest angle-adjustment is standard on the Trax Seat Frame.
1. Adjustment on Trax Seat Frame
a) Remove the securing bolt (A) on the sides of the backrest hinge plate.
b) Set at desired angle. There are ten holes (in 4º increments) to choose from.
c) Reinstall the front bolt and tighten both bolts securely.
M. SEAT DEPTH
The seat depth can be adjusted continuously along the seat rail.
a) To adjust, loosen the four bolts (B) from each side of the backrest pivot plate.
b) Reposition the backrest to the desired position.
c) Retighten bolts on each side of the backrest pivot plate.
N.SEAT HEIGHT AND ANGLE ADJUSTMENT
Adjusting the seat height can be done both at the front and the rear of the seat. Seat angle
can also be varied through front and rear seat height adjustments.
1. Front Seat Height Adjustment
a) Remove bolt (A) in the seat height strut (B). Adjust the upper and lower tube until the
desired front seat height is achieved. Each upper hole is 1" apart. Each lower hole is
1/2" apart. This allows 1/2" seat height increments.
b) Replace the bolt and secure the locknut.
2. Rear Seat Height Adjustment
a) Remove bolt (C).
b) Loosen bolt (D), but do not remove.
c) Adjust seat height to match one of three positioning holes (G). Each hole is 1" apart.
d) Refasten bolt (C) and retighten bolt (D).
e) To achieve 1/2" increments adjust position bolt (E) to either hole (F) and refasten.
O.WHEEL LOCKS
Wheel locks are installed by Sunrise when requested on the Quickie S-636.
1. Mounting
The wheel lock mounts to the motor mount. Use a torque setting of 100 in./lbs when adjust-
ing wheel locks.
a) Loosen bolts (D).
b) Slide mounting bracket toward rear wheel until clamp embeds into tire to prevent
wheel movement when in locked position.
c) Tighten screws.
NOTE–
Wheel lock adjustment will be done through the drive-wheel spokes.
P . SUSPENSION
N N O O T T E E – – Equivalent adjustments should be done to both the right and left suspension element.
It is important to properly adjust the pre-load and damping to ensure proper comfort and con-
trol for the rider.
1. Pre-Load Adjustment
With the rider seated in the chair and with batteries installed, insure that the main horizontal
member of the base frame is parallel to the ground. If it is not parallel, adjust spring collar (B) in
either direction to adjust. If the rear of the base frame is lower than the front, adjust the spring
collar clockwise when viewed from the rear of the chair. If the rear of the base frame is higher
than the front, adjust the spring collar counter-clockwise when viewed from the rear of the chair.
The spring pre-load ring should never be adjusted so that the shock spring is
less than four inches long with the chair unoccupied and the batteries installed.
Too much spring pre-load may cause the spring to fail.
108833 Rev. A
(FIG. 13)
(FIG. 14)
(FIG. 15)
(FIG. 16)
(FIG. 17)
WARNING
(FIG. 14, 15)
16
12
A
13
loosen all 4
B
move back
or forward
14
A
B
15
F
E
G
C
D
16
D
17
C
B
I X .
Advertisement
Table of Contents
