Introduction & Machine Specifications - Clarke IMAGE 16i Operator's Manual

Introduction and Machine Specification
The Image 16 is an extractor for cleaning the carpet. The machine applies cleaning solution to the carpet and
removes dirty solution and soil from the carpet. The Image 16 is equipped with a power brush. The extractor has
controls to start the solution pump, and vacuum motor. The extractor (floor spray and brush) can be operated
intermittently or continuously. This machine is intended for commercial use.
NOTE: When using the extractor to clean carpets, follow this procedure:
1. Do not walk on freshly cleaned carpets for at least four hours or until the carpet is dry to touch.
2. If aluminum or plastic pieces have been placed under the legs of furniture, do not remove them until
the carpet is dry.
3. Do not allow children or pets to crawl or walk around on the damp carpet.
4. Vacuum right after the carpet is dry and then vacuum the carpet once a week, or as often as needed.
Specifications:
Model
Code Number
Solution Pump (bar)
Solution Tank Capacity (l)
Recovery Tank (l)
Waterlift (m)
Vacuum (W)
Electrical
Power Cable
Spray Jets
Brush Size (cm)
Brush Motor Size (W)
Dimensions (cm)
Weight (kg)
Shipping WeightZ (kg)
Sound Level (dBA)
Vibration (m/s/s)
CLARKE TECHNOLOGY Image 16 230V Operator's Manual
Image 16i
STD-230V
04112B
6.8 Fixed
30.2
28.3
2.9
1,200Tangential discharge
230 Volt 50/60 Hz
11m 3-wire
Q. C. (5) 4 front, 1 rear
7.6 x 33
90
84 x 117 x 41
44.5
52
80
<2.5
Image 16ix
DLX-230V
04113B
0-6.8 variable
32.1
28.3
2.9
1,200 Tangential discharge
230 Volt 50/60 Hz
23m 3-wire
7.6 x 33
90
84 x 117 x 41
44.5
52
80
<2.5
Page 11