Routing Ffcs/Cables - Epson L200 Service Manual

L200/L201/L100/L101

1.4 Routing FFCs/cables

Scanner Unit /CIS (L200/L201)
Panel FFC
Panel FFC
Housing
When routing the Panel FFC, route it through the ribs (x7) of the Housing, and secure with double-sided tape (x3).
When routing the Scanner FFC, secure it together with the Ferrite Core on the Housing with double-sided tape.
When routing the Scanner Motor cable, pay attention to the following instructions.
• Secure the Ferrite core with the hooks (x2) on the rear of the Scanner Unit.
• Route the Scanner Motor cable through the ribs (x2) and hook (x1) on the rear of the Scanner Unit, and through the hole of the section A and make one
turn around the frame of the section A.
Head FFC CR Motor cable Main Board
Connect the following cable to the Main Board as shown in the figure above.
• PF Motor cable
• Power Supply Unit cable
• PF Encoder FFC
• CR Motor cable
• Head FFC
Disassembly/Assembly
Panel FFC
Bottom of the Scanner Unit
Ferrite Core
Scanner FFC
Ferrite Core
Rib
Hook
Section A
Scanner Motor cable
Double-sided tape
Main Board
PF Motor cable
Power Supply Unit Cable
Route the CR Motor cable through the ribs (x10) and make one turn around the rib A.
Route the CR Motor cable so as not to touch the surrounding gears.
Main Board
Connect to CR Encoder
PF Encoder FFC
Confirm the CR Encoder Head FFC is surely connected.
Route the Head FFC through the rib of the Carriage as shown above.
Routing FFCs/cables
CR Motor
CR Motor cable
CR Motor
Pick Assy
Printhead / Carriage
Head FFC
Rib
Revision A
Rib A
Pick Assy
Rib
Head FFC
Rib
31
Confidential