3.1. INSTALLATION REQUIREMENTS: SELECTING AN
ADEQUATE PLACE FOR SETTING UP YOUR EQUIPMENT
The location where you set up your equipment is very important. Please see to it that it meets following
conditions:
Power supply:
- Voltage:
- Frequency:
- Current:
Ambient conditions:
Operating environment
- Temperature: 18°C to 35°C
- Humidity: 20% - 60% non-condensing
- Recommended working environment
Temperature: 22-30°C
Humidity: 40-60%
Storage environment
- Temperature: -10°C to 60°C
- Humidity: 20% - 85% non-condensing
Variation rate
- Temperature: 2°C per hour
- Humidity: 5% per hour
Avoid using your Rockhopper 38 printer near heating systems, such as stoves or heaters.
Avoid using your printer under strong lighting, such as halogen lamps, light bulbs or direct sun light.
When selecting a place for your printer, leave at least 200 mm in front and at the sides, and 300 mm at the
rear, as shown in the illustration below.
3. SETTING UP THE UNIT
200 to 240 VAC or 100 to 120 VAC
50/60 Hz ± 1 Hz
< 10 A (110 V)
< 5 A (220 V)
Page
23
Rockhopper 38 – User's Guide
AP-75038, Rev. 1.0. – 27/05/04