Using Your Zotac Zbox Nano; Configuring Wireless Connection; Configuring Wired Connection; Using A Static Ip - Zotac ZBox User Manual
Hide thumbs
Also See for ZBox:
- Quick start manual (59 pages) ,
- User manual (32 pages) ,
- Instruction manual (24 pages)
Table of Contents
Advertisement
ZOTAC ZBOX nano
Click the icon
• Intel Rapid Storage Technology
Each driver must be installed individually
to ensure proper operation of the
ZOTAC ZBOX nano.
3.
Select the driver you want to install.
The driver installer should launch.
4.
Follow the onscreen instructions for the
selected driver to install.
5.
Restart the system.
Using your ZOTAC ZBOX nano
Configuring wireless connection
Please follow the instructions below to connect to a wireless network:
1.
Double-click the wireless network icon (pic) in the notification
area.
2.
Select the wireless network you want to connect to from the
list and click Connect.
3.
After connection is established, you will see "Connected."
Note 1: For security concerns, Do NOT connect to an unsecured network,
otherwise, the transmitted information without encryption might be visible to
others.
Note 2: Enter the network security key if necessary.
Configuring wired connection
Using a static IP
1.
Right-click the network icon in the
notification area and select "Open
Network Connections".
2.
Right-click "Local Area Connection" and
select "Properties".
3.
Highlight "Internet Protocol (TCP/IP)"
and click "Properties".
4.
Select "Use the following IP address".
5.
Enter your IP address, subnet mask and
Default gateway.
6.
Enter the preferred DNS server address if necessary.
7.
After entering all of the related values, click "OK" to finish the configuration.
22
to review the Page 2 of the driver DVD:
Advertisement
Table of Contents
