Wolf WWD30 Use & Care Manual page 12

Warming Drawer Use & Care
Cleaning and Care Recommendations
IMPORTANT NOTE: Make sure the warming drawer is off
and all surfaces are cool before cleaning any part of the
unit.
STAINLESS STEEL
Although stainless steel is resistant to most stains, it is not
totally impervious to damage. Salt and some cooking
liquids may pit and stain the surface. Always remove these
spills immediately.
Use a spray degreaser to remove fingerprints and greasy
spatters. Spray on a cloth and wipe surface. Buff dry
immediately to avoid streaking.
For hard water stains, use white vinegar and water.
Do not use abrasive cleaners (e.g., Comet or Soft Scrub);
they will permanently scratch the surface. Do not use steel
wool pads.
STAINLESS STEEL DRAWER FRONT
To clean the exterior of a classic or platinum stainless
steel drawer front, use a soft, nonabrasive stainless steel
cleaner like Signature polish and apply with a soft lint-free
cloth. Carbon stainless steel can be cleaned with mild
soap and water. Signature polish is available from
Signature Limited Laboratory, P. O. Box 13436, Dayton,
Ohio 45413, or call 877-376-5474.
To bring out the natural luster of all three stainless finishes,
lightly wipe the surface with a water-dampened microfiber
cloth, followed with a dry microfiber cloth. All work should
follow the grain direction of the finish. Better results are
obtained by keeping the cloth in continuous contact with
the metal.
IMPORTANT NOTE: Under no circumstances should you
use a metallic or highly abrasive cleaner or cloth, as this
will remove the carbon finish.
DRAWER RACK
Clean the chrome rack with a mild detergent and water.
After cleaning, rinse with clean water and dry thoroughly
with a clean cloth.
CONTROL PANEL
Be careful not to soak the control panel. Although the
panel is sealed, excessive moisture may cause damage to
the controls.
Use a glass cleaner to remove fingerprints and spills from
the surface of the control panel. Spray first on a cloth
before wiping the panel.
12