Clamp - Graco G-Max 7900 Instructions Manual

Clamp

Removal
NOTE: All Steps refer to F
1
Face of clutch housing
2
1.812 +.010 in. (46.02 +.25 mm)
3
Torque to 125 +.10 in-lb (14 +1.1 Nm)
4
Chamfer this side
7
F . 15
IG
1. Loosen two screws (16) on clamp (8).
2. Push screwdriver into slot in clamp (8) and remove
clamp.
Installation
NOTE: All Steps refer to F
1. Install engine shaft key (7).
2. Tap clamp (8) on engine shaft (A) with plastic mal-
let.
3. Press clamp (8) onto engine shaft (A). Maintain
dimension shown note 2 in Fig. 12. Chamfer side
must face engine.
Check dimension: Place rigid, straight steel bar (B)
across face of clutch housing (5). Use accurate
measuring device to measure distance between bar
and face of clamp. Adjust clamp as necessary.
Torque two screws (16) to 125 +10 in-lb (14 +1.1
N.m).
308870G
. 15.
IG
1
5
B
16
3
A
03483
. 15.
IG
Clutch Housing
Removal
NOTE: All Steps refer to F
2
8
4
F . 16
IG
1. Remove four cap screws (75) and lock washers (77)
which hold clutch housing (5) to engine.\
2. Remove screw (15) from under mounting plate (D).
3. Remove engine key (7).
4. Pull off clutch housing (5)
Installation
NOTE: All Steps refer to F
1. Push on clutch housing (5).
2. Install four cap screws (75) and lock washers (77)
and secure clutch housing (5) to engine. Torque to
200 in-lb (22.6 N.m).
3. Install cap screw (15) from beneath mounting plate
(D). Torque to 26 ft-lb (35.2 N.m).
. 16.
IG
5
7
77
D
15
. 16.
IG
Clamp
75
90
15