G-Counter Level Set; G-Analyzer Reset; G-Analyzer Calibration Setup - Kenwood KDC-MP732 Instruction Manual

Menu system
In Standby mode

G-Counter Level set

Calibrating G-Point. Setting the level according to
the kinds of vehicles.
Display Setting
"G-Counter : Level1" Counter is easy to go up.
"G-Counter : Level2"
"G-Counter : Level3" Counter is hard to go up.
• In the case of driving situations calling for few
accelerations, set the G-Point up to "G-Counter :
Level1". In the case of frequent accelerations, set it up
to "G-Counter : Level3".
In Standby mode

G-Analyzer Reset

Resets the value of G-Meter, G-Counter and G-
Analyzer Horsepower Analysis.
1
Select G-Analyzer Reset mode
Push the Control knob towards [FM] or [AM].
Select the "G-Reset" display.
2
Enter G-Analyzer Reset mode
Press the Control knob for at least 1 second.
3
Select the Reset item
Push the Control knob towards [FM] or [AM].
"G-Meter Reset": Reset the value of G-Meter.
"G-Counter Reset": Reset the value of G-Counter.
"G-Power Reset": Reset the value of G-Analyzer
Horsepower Analysis.
4
Reset the value
Press the Control knob for at least 2 seconds.
"Reset OK" is displayed.
5
Exit G-Analyzer Reset mode
Press the [MENU] button.
42
|
English
In Standby mode

G-Analyzer Calibration setup

G-Analyzer requires calibration for horizontal
acceleration and braking.
• To ensure accurate calibration, go through the
following steps at a level place where you can move
the vehicle straight ahead.
1
Park the vehicle in a horizontal location
2
Select G-Analyzer Calibration setup mode
Push the Control knob towards [FM] or [AM].
Select the "G-Calibration" display.
3
Enter G-Analyzer Calibration setup mode
Press the Control knob for at least 1 second.
"Stop" is displayed.
4
Start Calibration of horizontal direction
Press the Control knob.
Once "Move Forward" appears on the display, the
vehicle must be advanced.
5
Start Calibration of straight direction
Start moving the vehicle ahead.
Calibration of straight direction automatically
starts.
When the Calibration is finished, "Calibration OK"
is displayed.
• If you fail to complete the calibraton, "No Calibration"
is displayed. In such a case, repeat steps 1 through 6.
6
Exit G-Analyzer Calibration setup mode
Press the [MENU] button.