Connecting Wires To Terminals - Kenwood KDC-MP732 Instruction Manual

Connecting Wires to Terminals

To Kenwood disc changer/
External optional accessory
To connect these leads, refer to the
relevant instruction manuals.
To use the steering wheel remote control
feature, you need to an exclusive remote
adapter (not supplied) matches your car
is required.
REMO.CONT
Steering remote control
(Light Blue/Yellow)
(KDC-X790 only)
Fuse (10A)
Wiring harness
(Accessory1)
Power control wire (Blue/White)
Motor antenna control wire (Blue)
TEL mute wire (Brown)
External amplifier control wire
(Pink/Black) (KDC-X790 only)
Dimmer control wire (Orange / White)
FRONT • L
FRONT • R
REAR • L
REAR • R
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) · (To car chassis)
56
|
English
If no connections are made, do not let the wire come out from the tab.
When using the optional power amplifier, connect to its power
P.CONT control terminal.
Depending on what antenna you are using, connect either to the
control terminal of the motor antenna, or to the power terminal
ANT.
CONT
for the booster amplifier of the film-type antenna.
Connect to the terminal that is grounded when either the
telephone rings or during conversation.
MUTE
To "EXT.AMP.CONT. " terminal of the amplifier having the external
amp control function.
To car light control switch
White/Black
White
Gray/Black
Gray
Green/Black
Green
Purple/Black
Purple
Car fuse box
(Main fuse)
ACC
Sub Woofer right output (Red)
SUB
WOOFER
Sub Woofer left output (White)
Rear right output (Red)
REAR
Rear left output (White)
Front right output (Red)
FRONT
Front left output (White)
AUX right input (Red)
AUX IN
AUX left input (White)
FM/AM antenna input
To connect the Kenwood navigation system, consult your
navigation manual.
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
Ignition key
switch
Car fuse
box
Battery
– +