Stand By Mode - ViewSonic ViewPad 1000 User Manual

Power Saving Options
When battery power reaches critical low (3% remaining), the system enters
either one of the two power saving modes:

• Stand By mode

• Hibernate Mode - Save To Disk
Stand By Mode
In Stand By mode, hardware devices, such as display panel and hard disk, are
turned off to conserve energy. Click start > click Turn Off Computer > click
Stand By. To use the ViewPad
Save To Disk - Hibernate Mode
In this mode, all system data is saved to the hard disk before powering down.
When in the hibernate mode, very little power is drawn from the battery.
The amount of time the system requires to restore all its previous contents
depends on how much RAM has been installed on your ViewPad 1000.
Restoration times can range from 5 to 20 seconds.
For Windows XP Professional users, Save To Disk action is handled by the
operating system; therefore, no special disk partition or disk file is necessary.
To enable the hibernation function, click start > Control Panel > Performance
and Maintenance > Power Options > click the Hibernate Option > then check
the Enable hibernation option > OK.
The Power On/Power Management Button
The ViewPad 1000 uses a one-button design. This means that both the power on/
off and the system power management functions share the same physical button
as shown below. To enable the Stand By mode, see.
• Press and hold the Power On/ Power Management button for two seconds to
turn the unit On.
• Click the Power On/ Power Management button to put the system into Stand
by mode. If the Power On button is not set up to Stand by, click the Windows
start button > Control Panel > Performance and Maintenance > Power
Options > select the Advanced option. Under Power buttons, select Stand
by.
again, click the screen.
TM
ViewSonic ViewPad 1000 Tablet PC
Power Management light
Power Management button
22