Connecting Wires To Terminals - Kenwood KDC-MP5032 Instruction Manual

Connecting Wires to Terminals

To Kenwood disc changer/
External optional accessory
To connect these leads, refer to the
relevant instruction manuals.
If no connections are made, do not let the wire come out from the tab.
When using the optional power amplifier, connect to its
power control terminal.
Depending on what antenna you are using, connect either
to the control terminal of the motor antenna, or to the
power terminal for the booster amplifier of the film-type
antenna.
Connect to the terminal that is grounded when
either the telephone rings or during conversation.
To connect the Kenwood navigation system, consult
your navigation manual.
Rear left output (White)
Rear right output (Red)
Fuse (10A)
To car light control switch
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
Ignition key switch
Car fuse box
(Main fuse)
Battery
+ –
WOOFER
Power control wire (Blue/White)
P.CONT
ANT.
Motor antenna control wire (Blue)
CONT
TEL mute wire (Brown)
MUTE
Dimmer control wire (Orange / White)
White/Black
White
Gray/Black
Gray
Green/Black
Green
Purple/Black
Purple
Car fuse box
ACC
Ground wire (Black) · (To car chassis)
Sub Woofer left output
(White)
Sub Woofer right output
(Red)
SUB
Front left output (White)
Front right output (Red)
FM/AM antenna input
Wiring harness
(Accessory1)
Ignition wire (Red)
Battery wire (Yellow)
English
31
|