Tools And Materials Needed - Cobra MPC SERIES Installation & Programming Manual

COBRA INSTALLATION AND PROGRAMMING GUIDE
Introduction / Tools and Materials Needed
Introduction
COBRA INSTALLATION AND PROGRAMMING GUIDE
Introduction / Tools and Materials Needed

Tools and Materials Needed

1.
2.
3.
4.
The following will also be needed only for new installations:
5.
6.
7.
8.
9.
10. Square
11. Level
12. Masking tape
13. Drill w/chuck for up to 1" drill bits
14. Drill bit set
15. 2-1/8" Hole saw
57010-H
The MPC Cobra is a battery-powered manually programmed access control sys-
tem. Up to 100 individual codes can be programmed right at the keypad. A red and
green LED on the keypad provide visual indication for programming and access
events. Mechanical key override is possible when a 7-pin small-format inter-
changeable core (not included) is installed in place of the cylinder plug, which
comes standard. Either the plug or the IC core must be installed for the lock to
operate. When the cylinder is removed (using the cylinder control key) the lock
will unlock. Manual key override should only be necessary if the low battery out-
put indications have been ignored. (See also
The design allows for mounting on doors from 1-1/2" to 2" thick. A shim is avail-
able to mount the lock to a 1-3/8" door. An exterior gasket (EG option) is available
for application to exterior sides of doors.
Philips head screwdriver set
Allen wrench set
Loctite 242
4 "AA" Batteries (provided)
Full size door template (provided)
Pencil
Center Punch
Hammer
Chisel
BATTERY INFORMATION:
Page 2
on page 10).
12-19-2005