Table of Contents
Advertisement
COBRA INSTALLATION AND PROGRAMMING GUIDE
Programming Steps
Use the steps on this page to pro-
gram codes into the lock. The "*" key
is used like the <ENTER> key is on
a computer. After pressing the "*"
key, wait for the red and green LEDs
to stop flashing before proceeding to
the next step. If at any time the red
LED stays on while the green LED
flashes an error has occurred. The
flashing message will repeat three
times. Count the number of flashes
and consult the error code chart
below.
FLASHES ERROR CODE DESCRIPTION
2
Code too long
Maximum digits
6 • 12 button keypad
8 • 6 button keypad
3
Memory full, delete some
codes
4
Use Change Prog. code
procedure
5
Prog. Code entries do not
match, code not changed
6
Invalid entry, start over
7
Code for deletion not found
8
Code too short
Prog. code 5 digit minimum
User Code 3 digit minimum
9
Duplicate code
57010-H
Page 11
Programming Steps
12-19-2005
Advertisement
Table of Contents
