Error Mode - Westinghouse WGRTNG199 Nstallation & Maintenance Manual

Figure 28 – Installer Mode Screens
Index Default
1: EH
E0:00
2: cE OFF
3: In OFF
4: Fu
GA
5: FH
00
6: FL 00
7: dr NO
8: dI
NO
9: HA -
10: Cn 00
11: CI
01
12: Eh
ON
Table 21 – Installer Mode Descriptions – NOTE: Shaded Parameters Not Used on This Software Version
Toggle through displayed items by turning the dial
To change an item, press the Dial button
Displayed items can be changed by turning the dial
To save settings, press the Dial button
To leave Installer Mode, press button B
F. ERROR MODE
When the water heater encounters an error, the display will flash "Er" followed by a numerical code. The water heater shall enter a soft
lockout condition if the error is such that it can return to normal operation once the condition relieves itself (overheat conditions, NTC
open or shorts, etc.). The water heater shall enter a hard lockout if the condition indicates something more serious (flame, ignition,
condensate line, etc.) To clear a hard lockout Error Code, press the Power button.
The following screen will display when the water heater encounters an error.
Figure 29 – Error Mode Screen
Parameter
History
Clear Error History
System Reset
Flow Unit
N/A
N/A
Reset Burner Operation Time
Reset Number of Ignition
N/A
N/A
N/A
N/A
.
.
counterclockwise to lower, and clockwise to raise, the displayed value.
again.
again. The water heater will return to power off mode.
Description
Most Recent History Error Codes (H0 – H9)
Clears Error History
Restores System to Default Settings
(Burner operation time, Ignition cycles, and Supply
power time will not be reset)
Range: ON or OFF
Displays Flow Rate in Liters/Minute or Gallons/Minute
Range: GA or Li
N/A
N/A
Reset Burner Operation Time
Reset Number of Ignition
N/A
N/A
N/A
N/A
35
WHL-004 REV. 12.17.14