Icon Display Switching; G-Analyzer Display Selection; G-Analyzer Stop Watch - Kenwood eXcelon KDC-X991 Instruction Manual

General features
Display Type C

Icon Display Switching

Changing the Icon Display.
1
Enter Icon select mode
Using the Control knob, select "DISPLAY" >
"SIDE".
2
Switch the Icon display
Turn the Control knob or push it towards left
or right.
Select from the following displays:
Icon display
Source graphic
Text label
Album art (iPod or "Music Editor" media)
3
Exit Icon select mode
Press the Control knob.
⁄
• The Album art display function is not used to display the
image corresponding to the tag recorded in the Audio
file.
• If Album art display is selected during playback of an
iPod or "Music Editor" media on which no album art is
recorded, a source icon is displayed.
• During Album art downloading, "Down-loading" is
displayed. Downloading requires a maximum of 30
seconds.
Display Type E

G-Analyzer display Selection

Changing the G-Analyzer display.
⁄
• Before alternating G-Analyzer display, you are required to
setup <G-Counter Level setting> (page 22), <G-Analyzer
Calibration setup> (page 22), <G-Analyzer vehicle weight
setup> (page 23) and <G-Analyzer vehicle class setup>
(page 23).
1
Enter G-Analyzer display selection mode
Using the Control knob, select "DISPLAY" > "G-
MENU".
For the operation method, refer to <Function
Control mode> (page 11).
20
|
English
2
Select the G-Analyzer display
Turn the Control knob.
Select from the following displays.
G-Force Sensor display
⁄
Display
• G-Graphic display
"Source"
"Text"
"Photograph"
• G-Counter display
• The value of G-Meter display and G-Counter display can
3
Exit G-Analyzer display selection mode
Press the Control knob.
Display Type E

G-Analyzer Stop Watch

The control of stop watch can be started by G-
Analyzer function.
¤
• Do not use G-Analyzer stop watch on the Public roads.
1
Enter G-Analyzer Stop Watch mode
Using the Control knob, select "DISPLAY" >
"GMA" > "S.WATCH".
For the operation method, refer to <Function
Control mode> (page 11).
"STOP WATCH" is displayed.
2
Make the counter ready
Press the Control knob.
"Ready" is displayed.
- Graphic: Displays the condition of G in horizontal
direction (e.g; when turning the curve) by the graphic.
- Text: The maximum value of acceleration G, right
direction G, and left direction G is displayed by the
numerical value. The value of G is only the reference, so
is different from the actual value.
Adds the point of the acceleration level. The point is
determined after a lapse of 1 hr drive or at power off
(ACC Off ), and then it will be displayed by the graph.
Furthermore, the G-Counter displays the average of the
past data by the line. (The scale of graph is determined
along with the largest point among the past 10 data.)
be reset by <G-Analyzer Reset> (page 22).
G- Graphic display
G-Counter display