Date Mode; Synchronize Clock; Dsi (Disabled System Indicator); Display Illumination Control - Kenwood eXcelon KDC-X991 Instruction Manual

In Standby mode

Date Mode

Setting the date format.
1
Select Date Mode
Turn the Control knob.
Select the "Date Mode" display.
2
Enter Date mode
Press the Control knob for at least 1 second.
3
Select the date format
Turn the Control knob or push it towards up or
down.
4
Exit Date mode
Press the [FNC] button.
In Standby mode

Synchronize Clock

Synchronizing the RDS station time data and this
unit's clock.
Display Setting
"SYNC : OFF" Adjust the time manually.
"SYNC : ON" Synchronizes the time.
⁄
• It takes 3 to 4 minutes to synchronize the clock.
In Standby mode

DSI (Disabled System Indicator)

A red indicator will blink on the unit after the
faceplate is removed, warning potential thieves.
Display Setting
"DSI : ON" LED flashes.
"DSI : OFF" LED OFF.

Display Illumination Control

This function turns off the display when you
perform no operation for 5 seconds. This function is
effective when you are driving at night.
Display Setting
"Display : ON" Keeps the display on.
"Display : OFF" Turns off the display when you perform no
operation for 5 seconds.
⁄
• Set the Display Illumination Control when the
<Demonstration mode Setting> (page 53) is set to OFF.
• When the display is off, pressing any key will turn on the
display.
• When the display is off, you cannot perform any
operation except for the following:
• Volume
• Attenuator
• Selecting the source
• Ejecting the disc
• Turning off the power
• USB remove mode
• During function control, such as the Menu System, the
display stays on.
In Standby mode

Dimmer

Dimming this unit's display automatically when the
vehicle light switch is turned ON.
Display Setting
"Dimmer : ON" The display dims.
"Dimmer : OFF" The display does not dim.
47
|
English