Audio Adjustments; Cabin Selection; Dta (Digital Time Alignment) Setting; X'over Setting - Kenwood DPX-MP6110U Instruction Manual

Audio Adjustments

Cabin selection

You can compensate the delay of the sound arrival
time, which is caused by the installation position of
the speakers, by selecting your environment from
the following car types;
Car type (rear speaker position)
Not compensating.
Compact car (rear door)
Compact car (cargo)
Full size car (rear door)
Full size car (cargo)
Station wagon (rear door)
Station wagon (cargo)
Minivan (rear door)
Minivan (cargo)
Sport-utility vehicle (rear door)
Sport-utility vehicle (cargo)
Minivan Long (rear door)
Minivan Long (cargo)
Calls the value adjusted at <DTA> (page 17).
1
Enter Cabin select mode
>
Select "SOUND" "S-SET"
For how to select Function Control item, refer to
<Function Control> (page 6).
2
Select the car type
Turn the Control knob.
3
Exit Cabin select mode
Press the [FNC] button.
⁄
• You can compensate the distances in more details by
using <DTA> (page 17) function.
In addition, the value specified at <DTA> can be called
by selecting "User".

DTA (Digital Time Alignment) setting

Adjusting fine tuning of the speaker position
compensation value specified at <Cabin selection>
(page 17).
1
Enter DTA setting mode
>
Select "SOUND" "S-SET"
For how to select Function Control item, refer to
<Function Control> (page 6).
Display
"OFF"
"Compact1"
"Compact2"
"Full Size Car1"
"Full Size Car2"
"Wagon1"
"Wagon2"
"Minivan1"
"Minivan2"
"SUV1"
"SUV2"
"Minivan(Long)1"
"Minivan(Long)2"
"User"
>
"CABIN".
>
"DTA".
2
Select the speaker you want to set
Setting speaker
Front speaker
Rear speaker
Subwoofer
Turn the Control knob and push the center
when the desired item is displayed.
3
Set the compensation value of the speaker
position
Turn the Control knob.
Adjust between 0 and 440 cm.
Refer to <Appendix> (page 25) on how to set the
compensation value.
4
Exit DTA setting mode
Press the [FNC] button.

X'Over setting

You can set a X'Over value for the speakers;
Adjustment Item Display
Front High Pass Filter "HPF-Front"
Rear High Pass Filter "HPF-Rear"
Low Pass Filter "LPF"
Subwoofer level "SUB-W LEVEL" –15 — +15
Subwoofer Phase "SW PHASE"
1
Enter X'Over setting mode
>
Select "SOUND" "S-SET"
For how to select Function Control item, refer to
<Function Control> (page 6).
2
Select the item you want to set
Turn the Control knob and push the center
when the desired item is displayed.
3
Set the X'Over value
Turn the Control knob.
4
Exit X'Over setting mode
Press the [FNC] button.
Display
"DTA-Front"
"DTA-Rear"
"DTA-Sub"
Range
Through/40/60/80/100/120/
150/180/220 Hz
Through/40/60/80/100/120/
150/180/220 Hz
50/60/80/100/120/Through
Hz
Reverse (180°)/ Normal (0°)
>
"XOVER".
17
|
English