Table of Contents
Advertisement
I. Hardware Installation
Once all components are unpacked and the recommended connections and
environment are available, you are ready to start setting up your TriFIT 620.
Step 1
Plug the Male end of the db-9 cable into the connector labeled "PC Comm" on
the back of the TriFIT 620 unit.
Db-9 serial cable in back of TriFIT 620 to PC Comm
Step 2
Plug the Female end of the db-9 cable into an available 9-pin serial port of your
computer (Com 1 or Com 2). If using the TriFIT cart upgrade, this cable routes
out the side of the cart-see cart setup. You can use a laptop or desktop PC.
9
Advertisement
Table of Contents
