Program The Z-Wave Module - Honeywell L5200 Series Installation And Setup Manual

LYNX Touch Installation and Setup Guide
Programming the Control

Program the Z-Wave Module

The following system options are programmed in this section:
Option
Z-Wave
Temperature Display
Note: If applicable, preprogrammed defaults for the L5200/L7000 Control are shown on the screen unless otherwise noted.
SCREEN
Z - Wave
5100-100-067-V0
Z-Wave
Enabled-Installed Telephone
Temperature Display
Fahrenheit
Enables or disables the Z-Wave Module
Toggles between Fahrenheit and Celsius (for Z-Wave compatible Thermostats)
1. Enter Program Mode and default the panel (Refer to "Loading Factory Defaults").
2. Select "Z-Wave"
The System displays the following options:
3. Select "Z-Wave". The system toggles between the following options:
Enabled – Installed Telephone Side
Disabled
Select "Enabled – Installed Telephone Side".
4. If you wish to change the temperature format, select "Temperature Display". The
system toggles between the following options:
Fahrenheit
Celsius
5. Select "Save".
6. Select the "" key to return to the previous screen or the Home button to return to
the Home screen.
7. Include Z-Wave devices. (Refer to Including/Excluding Z-Wave Devices in the Home
Automation Guide P/N 800-16091 or higher.)
Function
ACTION
Z-Wave
Temperature Display
- 34 -