Table of Contents
Advertisement
Chapter 27 Loop Guard
The following table describes the labels in this screen.
Table 93 Advanced Application > Loop Guard
LABEL
Active
Port
*
Active
Apply
Cancel
298
DESCRIPTION
Select this option to enable loop guard on the Switch.
The Switch generates syslog, internal log messages as well as SNMP traps
when it shuts down a port via the loop guard feature.
This field displays the port number.
Use this row to make the setting the same for all ports. Use this row first
and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you
make them.
Select this check box to enable the loop guard feature on this port. The
Switch sends probe packets from this port to check if the switch it is
connected to is in loop state. If the switch that this port is connected is in
loop state the Switch will shut down this port.
Clear this check box to disable the loop guard feature.
Click Apply to save your changes to the Switch's run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
MGS3700-12C User's Guide
Advertisement
Table of Contents
Troubleshooting
