Table of Contents
Advertisement
Connecting Wires to Terminals
2WARNING
If you connect the ignition wire (red) and the battery wire (yellow) to
the car chassis (ground), you may cause a short circuit, that in turn
may start a fire. Always connect those wires to the power source
running through the fuse box.
2CAUTION
When only two speakers are being connected to the system,
connect the connectors either to both the front output terminals or
to both the rear output terminals (do not mix front and rear). For
example, if you connect the + connector of the left speaker to a
front output terminal, do not connect the - connector to a rear
output terminal.
Installation
■
Installation
Firewall or metal support
Screw (M4X8)
(commercially
available)
Self-tapping
screw
(commercially
available)
Metal mounting
strap
(commercially
available)
NOTE
Make sure that the unit is installed securely in place. If the unit
is unstable, it may malfunction (eg, the sound may skip).
— 62 —
Bend the tabs of the
mounting sleeve
with a screwdriver or
similar utensil and
attach it in place.
Optical wire (Provided with the KDS-P901)
2 CAUTION
When handling an optical wire for
wiring, use care not to exceed the
minimum wire bend radius of 30
mm. If you exceed the minimum
bend limit, optical fibers within the
optical wire may be damaged.
When installing the DVD receiver
unit on the vehicle, ensure that the
optical wire is not stuck between
the DVD receiver unit and vehicle
parts.
Advertisement
Table of Contents
