Kenwood Z910DVD[K] Instruction Manual page 69

Troubleshooting Guide
The following messages are displayed when certain problems are occurring in your system. Take the
recommended actions.
No disc magazine has been loaded in the changer. The disc magazine is not completely loaded.
Eject
] Load the disc magazine properly.
No disc in the unit.
] Insert the disc.
No disc has been loaded in the disc magazine.
No Disc
] Load a disc into the disc magazine.
No disc has been loaded in the disc magazine.
TOC Error
] Load a disc into the disc magazine.
The disc is very dirty. The disc is upside-down. The disc is scratched a lot.
] Clean the disc and load it correctly.
Nothing has been recorded on the MD.
Blank Disc
No tracks are recorded on the MD, although it has a title.
No Tr Disc
The faceplate of the slave unit being connected to this unit has been removed.
NO PANEL
] Replace it.
The unit is malfunctioning for some reason.
E-77
] Press the reset button on the unit. If the "E- 77", code does not disappear, consult your nearest service centre.
Something is wrong with the disc magazine. Or the unit is malfunctioning for some reason.("WRONG DISC FORMAT" is
Mecha Error
displayed on the monitor.)
] Check the disc magazine. And then, press the reset button on the unit.
If the "Mecha Error" code does not disappear, consult your nearest service centre.
The protective circuit in the unit activates when the temperature inside the automatic disc changer exceeds 60°C (140°F),
Hold Error
stopping all operation.
] Cool down the unit by opening the windows or turning on the air conditioner. As the temperature falls below 60°C (140°F),
the disc starts playing again.
If this indicator blinks, the DVD player is malfunctioning.
IN
] Eject the disc and try inseting it again.
If the disc cannot be ejected, press the eject button and hold it in until the disc is ejected.
The DVD software encoded for other region code.("WRONG REGION CODE" is displayed on the monitor.)
Region Error
Unsupported disc or the disc can't be read.("WRONG DISC FORMAT" is displayed on the monitor.)
Read Error
— 69 —