Weld Output Terminals; Connecting To Weld Output Terminals - Miller Trailblazer 302 Diesel Owner's Manual

5-7. Weld Output Terminals

1

5-8. Connecting To Weld Output Terminals

1
6
3
4
5
OM-217 454 Page 22
2
2
Tools Needed:
3/4 in.
.
A complete Parts List is available at www.MillerWelds.com
!
Do not connect to CC and CV
terminals at the same time.
1 Work Weld Output Terminal
2 Stick/TIG (CC) Weld Output
Terminal
3 Wire /CV Weld Output Terminal
For MIG welding, connect work cable
to Work terminal and wire feeder
cable to Wire (CV) terminal.
For Stick/TIG welding, connect work
cable to Work terminal and electrode
holder/TIG torch cable to Stick/TIG
(CC) terminal.
Use Process Selector switch to
select type of weld output (see
Section 6-3).
3
!
Stop engine.
!
Failure to properly connect
weld cables may cause ex-
cessive heat and start a fire,
or damage your machine.
.
Do not place anything between
weld cable terminal and copper
bar. Make sure that the sur-
faces of the weld cable terminal
and copper bar are clean.
1 Correct Weld Cable
Connection
2 Incorrect Weld Cable
Connection
3 Weld Output Terminal
4 Supplied Weld Output
Terminal Nut
5 Weld Cable Terminal
6 Copper Bar
Remove supplied nut from weld
output terminal. Slide weld cable
terminal onto weld output terminal
and secure with nut so that weld
cable terminal is tight against cop-
per bar.
Tools Needed:
3/4 in.
804 195-A
803 778-B