Removing The Unit - Kenwood KDV-MP735 Instruction Manual

Removing the Unit

Removing the hard rubber frame
1
Upper the frame and pull it forward as shown in
the figure.
2
When the upper level is removed, remove the
lower two locations.
• The frame can be removed from the bottom side in the
same manner.
• When you mount the "hard rubber frame, " take care to
face its upward and downward sides correctly. The side
having closer claws must face upward, and the one
having wider claws must face downward.
38
|
English
Lock
Removing the Unit
1
Refer to the section 'Removing the hard rubber
frame' (page 38) and then remove the hard
rubber frame.
2
Remove the screw (M4 × 8) on the back panel.
3
Insert the two removal tools deeply into the slots
on each side, as shown.
Screw (M4X8)
(commercially available)
• Be careful to avoid injury from the catch pins on the
removal tool.
4
Pull the unit all the way out with your hands,
being careful not to drop it.
Face the side having
a projection inward.
Accessory2
Removal tool