Fluke 28 II Ex Getting Started page 13

•
Do not work alone.
•
Do not touch voltages >30 V ac rms, 42 V
ac peak, or 60 V dc.
•
Use only correct measurement category
(CAT), voltage, and amperage rated
probes, test leads, and adapters for the
measurement.
•
Remove all probes, test leads, and
accessories that are not necessary for
the measurement.
•
Keep fingers behind the finger guards on
the probes.
•
Limit operation to the specified
measurement category, voltage, or
amperage ratings.
•
Measure a known voltage first to make
sure the Product operates correctly.
•
Measure for hazardous voltage without
the Low-Pass Filter.
•
Do not apply more than the rated
voltage, between the terminals or
between each terminal and earth ground.
•
Do not touch the probes to a voltage
source when the test leads are
connected to the current terminals.
Shop for Fluke products online at:
•
Connect the common test lead before
the live test lead and remove the live test
lead before the common test lead.
•
Replace the batteries when the low
battery indicator shows to prevent
incorrect measurements.
•
The battery door must be closed and
locked before you operate the Product.
•
Do not use the Product if it operates
incorrectly.
•
Do not use and disable the Product if it
is damaged.
MyFlukeStore
www. .com
True-rms Digital Multimeter
EX Safety Information
1.877.766.5412
5